Zulgtal Lab's
the originator of the "Ultra-Colloid" Mineral Supplements
Zulgtal Lab's
jjjjj
Thank you for visiting
TrueHealthFacts.com
Copyright © 2014 TrueHealthFacts.com  All rights reserved.

ZULGTAL LABS PRODUCT






ZULGTAL LABS PRODUCT QUALITY TESTING SUMMARY (A-E)

A. Concentration (calibrated in parts per million) Tests are done for
both ion concentration and suspended particle concentration Some form
of spectra graphic analysis is a good way to determine concentration of
trace metals particulates in suspension. Ionic silver content in silver
colloids can be adequately determined by initial Conductivity testing
and ultimately weighing the silver content after evaporating out the water

B. Average particle size

Any colloid worth its salt for bio-availability must maintain particulate
sizes  in the single or perhaps double digit NANOMETER (billionth of
a meter) range.  Zulgtal Labs requires scattered laser light intensity
measurements from suspended  particles which can be measured within
a  nanometers of a single Silver atom. (2.8 angstroms or .28 nanometers)

C. Total Additive particulates total surface area(the most significant
measurement) can then be determined by multiplying the average
particle size/area by the particle count per volume of water they are
suspended in.   These measurements tell us that a given weight of silver
broken into smaller and smaller particles, increases the total surface
area with which to expose to a pathogen as in the case of silver or
enable active transport in absorption and subsequent biological
reactivity on a cellular level.  The strength of taste or “taste que” of any
colloid is dependant on the total surface area exposed to the tongue.  
This fact “Taste Que Strength” IS YOUR BEST EVIDENCE OF A
SUFFICIENTLY CONCENTRATED PRODUCT.  
You can’t easily
fool the tongue, if the tongue says no taste, the total particulate
count surface area is weak, the most common colloidal plague.  
Would you continue buying  orange juice that was to weak to taste?
If you properly understood what was just stated then the various
confusing types of colloidal concentration measurements typically found
on the bottle such as PPM measurements, with are actually a calibrated
TDS meter  Conductivity in uS/cm  or number, or PPM measurements
based on the number of  mg/liter,
The stated concentration
measurement means or promotion will be of little consequence if
your tongue says “its there” or it says “not there”.
 This fact can be
of considerable consequence because the most
prominent colloidal
producers products are “terribly tasteless”.

D. Agglomeration
The next issue of magnitude in significance among
colloidal products is
“AGGLOMERATION“. which would not likely
occur among weakly concentrated products because typically as you
place heavier and heavier concentrations of colloidal particles in
suspension, they begin sticking together, becoming heavier and finally
falling out of solution found as a dark ”agglomeration cloud”, at the
bottom of your bottle, the most obvious and second “Curse of
Colloids”.   Zulgtal labs colloidal technology enables a process that
places
an extreme repulsive charge “Zeta Potential”on each
particulate, disabling, in fact reversing their tendency to
“Agglomerate” as concentration increases.
You get a strong “Taste
Que”in a Zulgtal Labs products because their repulsive charge process
grants
stronger concentration without agglomeration.

Other colloidal solution tests

For Silver solution colloids, since silver is photosensitive, light causes
agglomeration. This problem is solved in three ways.

1.  Dark bottles

2.  Long term storage out of direct sunlight.

3.  A proprietary non additive process involving the silver ion cloud.

E. Shelf Life The above attention to detail and quality control constitutes
primary influence upon the third consumer recognizable issue of SHELF
LIFE. If the above issues are properly managed and the bottle contents
are closed and not contaminated by the user, then shelf life for any “Pure
Colloid” should be in terms of years not months

Further colloidal characteristics Measurements such as Turbidity, pH,
and magnetic fields though somewhat significant to a lab technician in
controlling his processes are not worth covering in this text.

Although Zulgtal Labs recognizes that no layman possesses the Lab test
facilities necessary for ultimate determination of the above diverse
technical colloidal characteristics the above summary list enables the
consumer a visibly detectable criteria that will suffice to eliminate most
other products from the running.
Ultra Colloidal Minerals
ZULGTAL LABS PRODUCT
QUALITY TESTING
Pages