Zulgtal Lab's
the originator of the "Ultra-Colloid" Mineral Supplements
Zulgtal Lab's
jjjjj
Thank you for visiting
TrueHealthFacts.com
Copyright © 2014 TrueHealthFacts.com  All rights reserved.

For decades the broad spectrum antibiotic quality of Colloidal Silver and the
increased absorption factors over mainstream mineral supplements have
rested in the hands of companies with REAL colloidal science production,
testing equipment and protocols for superior quality colloids.
Zulgtal Labs
(Supplier for Silver Mountain Minerals™ US marketing contracts)
commitment to superior products and market base education in the US is
providing increasingly better support of the following colloidal products
analysis tests.

Standardized tests are the best way to ultimately enable consumers to
differentiate poorly regulated predominantly poor grade colloids that “sour
the market” from products that deliver concentrated
ULTRA-COLLOIDAL
PROPERTIES.

HOW TO IDENTIFY A SUPERIOR COLLOID: 8 CRITERIA.

I. Ionically concentrated solutions (generally clear) are more valuable where
the element is not significantly retained by the body such as silver.  
Essential Body Elements more retained are more usable in higher colloidal
particle proportion (generally colored)

II. Only purchase a colloidal product stating on the label as containing
particle size averages in the lower angstrom (10 billionth of a meter) range

III. Only purchase a colloidal product stating on the label as being non
photo sensitive. Visible signs of photo sensitivity appear easily in inferior
colloidal products when agglomeration occurs. The larger particulate
solutions with poor zeta potential fall out of solution and are found as a
residue at the bottom of the bottle. Agglomeration may be caused by many
factors which collectively represent the most important issues for the
consumer to look for.

IV. COLOR and TASTE if noticeable and dark with blue or brown hues for
silver products are usually indicators of large particle agglomeration, if light
and more yellow color yet still plainly visible indicates a smaller particle mid
range product. Visibly clear but not actually optically clear indicates either
highly dilute, highly ionic or in rare cases those
“tiny to invisible” highly
desired angstrom size particles, the mark of an excellent colloid. Tasting the
product for that “slight pucker” yet distinguished metallic taste is necessary
to eliminate the clear but dilute product. A sour, non metallic taste
eliminates the heavily ionic product. The only known exceptions are a few
products advertised as ionic but are actually neither, and the cheapest
selection because they are likely “acid leached” these have a quite nasty
taste because they will still contain residues of that process.

V. Only purchase a colloidal product stating on the label as having no
residues fillers, binders, buffers, stabilizers or other added agents. Only
pure distilled water and the high purity element alone is acceptable.
Although bad press regarding Argyria has diminished the accessibility of
cheap colloidal silver makers, peddlers from these sources often use salt or
other known electrolyte chemicals to seed the solution to make it
conductive to begin the electrically driven deposition. These additives like
the above also cause a foreign taste.

VI. Only purchase a colloidal product stating on the label concentrations not
exceeding 50 PPM unless specifically stated as PPM calibrated conductivity
relating to Ionic mineral concentration.   Extremely high numerical figures
are invariably highly ionic products containing few colloidal particles.  
Zulgtal Labs has produced Ionic Silver samples exceeding 9000 as a  
conductivity measurement uS/cm  but contained less than 1 PPM total
silver per liter. Only ignorance would represent this 9000 figure as a PPM
concentration for pure colloids only measured in mg/L,  yet a large number
of companies do so.

VII. Only purchase a colloidal product stating the address and source of a
reputable lab with access to standard testing for primary colloidal
characteristics.

VIII. If several colloidal elements are included in the same bottle, seriously
consider the way they are proportioned as their extreme differing body
requirements coupled with the higher absorption factors pose some
significant considerations which are further explained on the BODY
ELEMENTS PROPORTIONING CHART. Expensive colloids and fancy
labels do not make a quality product, LOOK FOR SECONDARY
SIGNATURES OR SEALS OF INDEPENDENT TESTING, such as the
laser test. Knowledge and facts will better maximize the purchasing power
of your dollar.

NOTE:  For further info on product quality selection see
“Colloidal Vs Ionic debate”
Pages
QUALITY Check List
Quality Check List